chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Restraints - Airbag Light ON/DTC's 52/56/B1378|Page 7847 > < Restraints - Passenger Presence System Information|Page 7838
Page 1
background image

Side Air Bag: Customer Interest
Restraints - Airbag Light ON/DTC's 52/56/B1378

TECHNICAL

Bulletin No.: 07-09-41-007A

Date: May 14, 2009

Subject: Airbag Readiness Light ON, DTCs 52, 56, B1378 and/or B1382 Set (Install Updated Side Airbag Connector)

Models:

2004-2008 Chevrolet Aveo
2005-2008 Pontiac Wave (Canada Only)

 ................................................................................................................................................................................................................................................ 
Supercede:
This bulletin is being updated to add model years. Please discard Corporate Bulletin Number 07-09-41-007 (Section 09 - Restraints).

 ................................................................................................................................................................................................................................................ 

Condition

Some customers may comment that the airbag readiness light in the instrument panel cluster stays on after starting vehicle. 

Technicians may find DTCs 52/B1378 (LF Side Deployment Loop Resistance Above Threshold) and/or 56/B1382 (RF Side Deployment Loop
Resistance Above Threshold) set.

Cause

When driving or adjusting the seat, the electrical connector for the side airbag may move or pull apart slightly, resulting in momentary high resistance.
There is no impact to airbag performance.

Correction

Remove the original side airbag connector and install the service kit following the procedure below.

1. Check for DTCs using a scan tool.
2. If DTCs 52/B1378 and/or 56/B1382 are in active mode, reconnect the side airbag wiring harness to change the DTC mode from active to history.
3. Clear the DTCs.
4. Wait 10 seconds after removing the key from the key cylinder.

Important
Be sure to disconnect all electrical connectors under the seat.

5. Remove the seat assembly. Refer to Front Seat Replacement - Bucket in SI.

6. Cut both sides of the old connector approximately 2 in (5 cm) from the connector (1).

Restraints - Airbag Light ON/DTC's 52/56/B1378|Page 7847 > < Restraints - Passenger Presence System Information|Page 7838