Beretta L4-121 2.0L (1987)
FIGURE 2
BERETTA ONLY
^
Remove secondary latch assembly and replace with new latch assembly (P/N 10074017). Discard production locator screw (P/N 11508544) Figure
2.
CORSICA AND BERETTA
^
Check operation - While slowly lowering hood, secondary latch must slide down newly installed skid plate until fully engaged.
^
Should secondary latch rest on catch surface without sliding down sloped surface of skid plate, loosen screw (P/N 11503632)
(2)
places (See Figure 2). If not previously removed, remove and discard production locator screw (P/N 11508544) and adjust secondary latch
forward slightly. Tighten screw (P/N 11503632)
(2)
places. Check operation by slowly lowering hood as before.
^
If locator screw (P/N 11508544) is removed for either secondary latch replacement (Beretta) or for secondary latch adjustment (Corsica or
Beretta), a new (P/N 11508544) locator screw must be installed. It may be necessary to first drill a 9/64" pilot hole if secondary latch assembly
required adjustment for proper operation.