Beretta L4-121 2.0L (1987)
WIRING HARNESS BEHIND GLOVE BOX
TO:
ALL CHEVROLET DEALERS
Some 1987 Beretta or Corsica models may experience a rattling noise behind the glove box. This condition could be due to a loose wiring harness hitting
the glove box.
To repair this condition, remove the glove box and install one clip, P/N 20556873, around the ECM harness and another clip (same part number) around
the instrument panel harness on either side of the 15 pin connector. Push these two clips into the upper (black) dash mat surface to hold the harness away
from the glove box.
Use applicable labor operations and time.