Beretta L4-121 2.0L (1987)
Cowl: Customer Interest
Cowl Vent Panel - Wavy/Poor Appearance
Number:
87-102
Section:
10
Date:
April 1987
Subject:
COWL VENT PANEL APPEARANCE
Model and Year:
1987 CORSICA AND BERETTA
TO:
ALL CHEVROLET DEALERS
Customer comments that the cowl vent panel is wavy or has a
poor appearance can be repaired by installing a later design
panel. Vehicles assembled prior to the following
breakpoints had early design panels, some of which are loose or wavy:
PLANT
VIN BREAKPOINT
Wilmington
104680
Linden
101053
The later design panels are slightly longer. The part
numbers for the later design panels are 10077402 (R.H.) and 10077403 (L.H.).
SERVICE CORRECTION
1.
Remove wiper arms.
2.
Pry off attaching fasteners and remove drivers side vent panel. Remove hose from drivers side wiper arm.
3.
Remove passenger side vent panel. Pull off hose from wiper arm.
4.
If the plastic windshield support stops extend above the thickness of the glass, trim them flush with the
glass.
5.
Reverse the procedure and install later design vent panels.
Labor Operation Number:
T1203
Labor Time :
.4 Hour