Beretta L4-121 2.0L (1987)
4
MILEAGE
Enter mileage at time of transaction. (If not available, enter "0".)
5
CC/FC
Code is preprinted on form.
6
LABOR OPERATION
Labor Operation is preprinted on form.
7 & 8 SUBLET DMN &
Enter total amount of reimbursement. (Do not enter parts or labor hours
LINE TOTAL
on claim.)
9
AUTH CODE
If the amount of reimbursement approved is $500 or less, no authorization
is needed. If the amount exceeds $500, advise customer to contact Chevrolet Customer Assistance at
1-800-222-1020.
10
REQUESTED
Dealer Service Manager enter amounts determined from owner supplied
REIMBURSEMENT
invoices or paid receipts, which are covered.
11
APPROVED AMOUNT
Dealer Service Manager to determine based on reimbursement policy of
this bulletin. If the total amount exceeds $500, contact Chevrolet Branch Customer Assistance
Representative for instructions.
12
740 STAMP
See Item # 11 to determine need for authorization.
13
DEALER REFERENCE
INFORMATION
A
Enter Document Number and Line Number on which claim was submit-
ted
B
Enter Claim Memo Number and Date when claim is credited.
C
Enter number of dealer check to owner, if applicable. Date check was
written, if applicable. Date copy of check was attached to OWNER REQUEST FOR REIMBURSEMENT
file.
14
OWNER INFORMATION
Must include telephone number.
15
DEALER INFORMATION
Includes Dealer Code, Dealer Name, Service Manager's signature and
social security number. To be completed by Service Manager.
16
EXPLAIN
Should the dealer Service Manager determine, after review of owner's
invoices/receipts, that the reimbursement case is not eligible; Service Manager should write reason on
worksheet, explain to owner, and place a copy of the worksheet in the file.
17
The dealer is then to issue the owner a check for the reimbursement in the approved amount. A copy of the
check issued to the owner is to be attached to the dealer's file copy of the request and retained for 24 months from date of credit.
Instruction Sheet
INSTRUCTION SHEET
FOR EFFECTIVE REPAIR, USE ALL PARTS IN KIT REGARDLESS OF ORIGINAL CONDITION.
SERVICE PROCEDURE FOR INSTALLING
"SPECIAL" VALVE BODY RINGS ON RACK AND PINION ASSEMBLIES WITH HARD STEERING
ON INITIAL START-UP
READ INSTRUCTIONS COMPLETELY AND CAREFULLY BEFORE PROCEEDING.
Some complaints about the power steering system on inital start up may be reported as:
^
Reduced power steering assist when parking.
^
Increased steering effort.
For further information, refer to the "Steering Diagnosis" section in vehicle service manual.
