Beretta L4-121 2.0L (1987)
Windshield: Customer Interest
Windshield - Side-to-Pillar Molding Poor Fit
Number:
88-24
Section:
10
Date:
Sept., 1987
Subject:
WINDSHIELD SIDE-TO-PILLAR REVEAL MOLDING POOR FIT
Model and Year: 1987-88 BERETTA, CORSICA
TO:
ALL CHEVROLET DEALERS
Some comments have been made that the windshield side-topillar reveal moldings have a poor fit at the upper corners on subject vehicles.
Field repairs can be accomplished by installing a revised windshield side-to-pillar reveal molding per the service procedure below. The part numbers for
the revised moldings are:
Coupe
R/S
10076028
L/S
10076029
Sedan
R/S
10076030
L/S
10076031
Service Procedure
1.
Open front door.
2.
Remove sealing strip in area of windshield side reveal molding.
WINDSHIELD SIDE-TO-PILLAR REVEAL MOLDING (DRIVER'S SIDE)
3.
Remove four screws, (see illustration).
4.
If necessary, elongate the four holes and slots in the new reveal moldings so that the molding end will fit flush to the roof.
5.
Install moldings and reverse the tear down procedure.
Labor Operation
Labor
Number
Time
Right side, elongate
B7570
.3 Hours
holes, and replace.
