chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

A/T - DEXRON(R)-VI Fluid Information|Page 2931 > < A/T - DEXRON(R)-VI Fluid Information|Page 2929
Page 1
background image

Fluid - A/T: Technical Service Bulletins
A/T - Fluid Level Checking Procedure

Number: 93-98-7A

Section: 7A

Date: FEB. 1993

Corporate Bulletin No.: 377101

ASE No.: A2

Subject:
AUTOMATIC TRANSAXLE FLUID LEVEL CHECKING PROCEDURE

Model and Year:
1990 CELEBRITY
1990-93 CAVALIER, CORSICA, BERETTA AND LUMINA
1990-93 LUMINA APV

TRANSMISSION APPLICATIONS:

1990-93 HYDRA-MATIC 3T40 (RPO MD9) 
1990-93 HYDRA-MATIC 4T60 (RPO ME9) 
1991-93 HYDRA-MATIC 4T60-E (RPO M13) 
1993 HYDRA-MATIC 4T80-E (RPO MH1)

TRANSMISSION MODELS:

All

SUBJECT:

Automatic Transaxle Fluid Level Checking Procedure

VEHICLE APPLICATIONS:

A, J, L, W Cars AND U-VAN

BULLETIN COVERS:

Transaxle fluid level checking and condition information. This updates all information previously published for 1990-93 HYDRA-MATIC 3T40, 4T60,
4T60-E and 4T80-E transaxles.

Due to enhancement of assembly plant fluid fill capabilities, it is especially important to warm the transaxle up to operating temperature before
determining that fluid needs to be added. If the transaxle fluid is close to operating temperature, the fluid level may read slightly below the "ADD" mark.
DO NOT ADD FLUID UNLESS THE TRANSAXLE IS AT OPERATING TEMPERATURE AND THE DIPSTICK SHOWS FLUID LEVEL IS
BELOW THE CROSSHATCHED AREA.

TRANSAXLE FLUID LEVEL INFORMATION:

Checking fluid level and condition (color and smell) at recommended service intervals will provide early diagnosis information about the transaxle. This
information may then be used to correct a condition that, if not detected early, could result in major transaxle repairs.

When adding or changing fluid, use only DEXRON(R)-IIE. Refer to Maintenance and Lubrication (Service Manual Section 0B) for maintenance
information and service intervals.

NOTICE:

Do not overfill. Overfilling will cause foaming, loss of fluid, shift complaints and possible damage to the transaxle.

Fluid level should only be checked when it reaches a normal operating temperature of 82-93 degrees C (180-200 degrees F). This temperature is reached
after approximately 24 km (15 miles) of driving.

TRANSAXLE FLUID COLOR:

A/T - DEXRON(R)-VI Fluid Information|Page 2931 > < A/T - DEXRON(R)-VI Fluid Information|Page 2929