Beretta L4-138 2.3L DOHC QUAD 4 (1991)
Defogger Switch: Service and Repair
Fig. 5 Instrument Cluster Bezel Removal. 1991-92 Models
Fig. 6 Headlight & Windshield Wiper Assembly Switch.
Refer to Figs. 5 and 6 when performing the following procedure.
1.
Disarm airbag as outlined in MAINTENANCE PROCEDURES/AIRBAG DEACTIVATION. Failure to do so may result in accidental
deployment of airbag, possibly causing personal injury.
2.
Disconnect battery ground cable.
3.
Remove instrument cluster bezel.
4.
Squeeze small switch knob at side and pull straight out.
5.
Insert a suitable flat blade screwdriver into slots adjacent to center of inner knob and disengage knob from switch.
6.
Remove switch to bezel screws, then switch.
7.
Reverse procedure to install noting the following:
a. When positioning inner knob to switch, make certain tabs align with slots, then press to secure.
b. Position outer knob on switch and align ``D'' shaped hole in knob to shaft on switch, then press to secure.
c. After all work has been completed, rearm airbag as outlined in MAINTENANCE PROCEDURES/AIRBAG ACTIVATION.
