Beretta L4-138 2.3L DOHC QUAD 4 HO MFI VIN A (1994)
dealer, and arrangements made to make the required correction according to the instructions contained in this bulletin. This could be done by mailing to
such owners a copy of the owners letter accompanying this bulletin. Campaign follow-up cards should not be used for this purpose, since the owner may
not as yet have received the notification letter.
In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.
This bulletin is notice to you that the new motor vehicle. included in this campaign may not comply with the standard identified above. Under Section
108 of the National Traffic and Motor Vehicle Safety Act, it is illegal for a dealer to sell a new motor vehicle which the dealer knows does not comply
with an applicable Federal Motor Vehicle Safety Standard. As a consequence, if you sell any of these motor vehicles without first performing the
campaign correction, your dealership may be subject to a civil penalty up to $1,000 for each such sale.
Parts Information
No parts are required to complete this campaign.
Service Procedure
Notice:
A suspension type-contact hoist must be used to perform the following inspection procedure. If the rocker panel reinforcement has been omitted, the
welded flange that serves as a lift point for frame-contact type hoists may not have sufficient structural rigidity to support the vehicle, and substantial
damage to the vehicle could occur if the rocker panel reinforcement has been omitted.
1.
Raise vehicle on suspension-contact type hoist (see "Notice", above)
2.
Inspect the right rocker panel area for the presence of the rocker panel reinforcement by carefully observing the underside of the RH rocker panel
area along the outboard side of the RH welded flange. There should not be any gaps or openings in the horizontal surfaces of the sheet metal in
