chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

All Technical Service Bulletins for Hydraulic Control Assembly - Antilock Brakes: > < Brakes - ABS Light ON, DTC 46 & 86 (C1246 & C1286)|Page 4663
Page 1
background image

Hydraulic Control Assembly - Antilock Brakes: Customer Interest
ABS - Lamp ON/DTC's 42 and 86 Set

FILE IN SECTION: 5 - Brakes

BULLETIN NO.: 53-50-10

DATE: May, 1995

SUBJECT:
Anti-Lock Brake System (ABS) Light On - Diagnostic Trouble Codes (DTC's) 42 and 86 Set (Replace Hydraulic Modulator)

MODELS:
1993-95 

Buick Skylark

1993-95 

Chevrolet Beretta, Corsica, Cavalier

1993-95 

Oldsmobile Achieva

1993-95 

Pontiac Grand Am

1993-94 

Pontiac Sunbird

1995 

Pontiac Sunfire

CONDITION

Some owners may comment that the Anti-Lock Brake System (ABS) light remains on. Diagnostic Trouble Codes (DTC's) 42 and 86 will be set. DTC's
will usually set 5 to 8 drive cycles in a row and then become history codes.

CAUSE

DTC's will be set due to a momentary delay within the ABS hydraulic modulator.

CORRECTION

Important: 

If DTC 42 is current DTC, the Diagnostic Trouble Tree in Section 5E1 of the Service Manual will lead to replacement of the motor pack. If the
following diagnosis does not lead to replacement of the hydraulic modulator, then the motor pack should be replaced.

Diagnosis

^

If DTC 42 has set 10 or less drive cycles and is no longer a current code (ABS not operating, ABS indicator off), replace the hydraulic modulator.

^

If DTC is current, cycle the system by starting the engine with your foot off the brake pedal. If the ABS indicator remains on, turn the ignition off and
repeat the procedure. If within 10 cycles the ABS indicator is off and the code is no longer current, replace the hydraulic modulator.

^

If the above diagnosis does not lead to replacement of the modulator, follow DTC 42 Trouble Tree in Section 5E1 of the Service Manual.

Repair Procedure

If the condition is confirmed through the above diagnosis, the hydraulic modulator must be replaced, P/N 18023364. This is a new part number that has
been released. Do not use previously released hydraulic modulator part numbers. Refer to Section 5E1 of the Service Manual for hydraulic modulator
replacement procedure.

Parts are currently available from GMSPO.

WARRANTY INFORMATION

For vehicles repaired under warranty, use:

Labor 

Operation 

Labor Time

H2518 

Use published labor operation time.

All Technical Service Bulletins for Hydraulic Control Assembly - Antilock Brakes: > < Brakes - ABS Light ON, DTC 46 & 86 (C1246 & C1286)|Page 4663