Beretta L4-138 2.3L DOHC QUAD 4 HO MFI VIN A (1994)
Fig. 16 Tensioner Bracket Assembly
1. Disconnect battery ground cable.
2. Loosen drive belt tensioner and remove drive belt.
3. Remove alternator assembly, Fig. 15 .
4. On models with A/C, remove oil filter and rear compressor bracket. Remove front compressor mounting bolts, then position compressor aside.
5. On models less A/C, remove idle pulley brace attaching bolts, then the brace.
6. On all models, raise and support vehicle.
7. Remove right splash shield.
8. On all models, remove chain housing to belt tensioner bracket brace, Fig. 16 .
9. Remove five bolts retaining bracket to block.
10. Remove bracket from wheel opening.
11. Reverse procedure to install. Tighten fasteners to specifications.
