Beretta L4-138 2.3L DOHC QUAD 4 HO MFI VIN A (1994)
Refrigerant Oil: Capacity Specifications
The A/C system requires 240 ml (8 fl. oz.) of Polyalkylene Glycol (PAG) refrigerant oil.
Polyalkylene glycol (PAG) refrigerant oil must be added to the system when components are replaced, as follows:
a. All Compressors (drain and measure the oil.
^
If less than 30 ml (1 oz.) is drained - add 60 ml (2 oz.) to the new compressor.
^
If more than 30 ml (1 oz.) is drained - add same amount that was drained to the new compressor.
b. Receiver Dehydrator.
^
Add 105 ml (3.5 oz.) to receiver dehydrator.
c. Evaporator.
^
Add 90 ml (3 oz.) oil.
d. Condenser.
^
Add 30 ml (1 oz.) oil.
e. Refrigerant oil loss due to a large leak:
^
If the refrigerant charge is abruptly lost due to a large refrigerant leak, approximately 90 ml (3 oz.) of refrigerant oil will be carried out of the
system with the refrigerant. Any failure that causes an abrupt refrigerant discharge will experience this oil loss. Failures that allow the
refrigerant to seep or bleed off over time do not experience this oil loss.
^
Upon replacement of a component which caused a large refrigerant leak, add 90 ml (3 oz.) of new polyalkylene glycol (PAG) refrigerant oil
plus:
^
The required amount of oil for the particular component (as outlined above). Add the oil directly to the replaced component if possible. If the
oil cannot easily be added to the replaced part, add the oil to the receiver dehydrator.
