Beretta L4-138 2.3L DOHC QUAD 4 HO MFI VIN A (1994)
Discriminating Sensors and Arming Sensors: Service and Repair
Passenger Compartment Sensor
WARNING: The diagnostic energy reserve module or sensing and diagnostic module (DERM/SDM) can maintain enough voltage to cause
air bag deployment for up to two minutes after the ignition switch is turned off and the battery is disconnected. Servicing the SIR system
during this period may result in accidental deployment and personal injury.
1. Disarm system as described in Air Bag System Disarming & Arming.
2. Remove console, left front seat and track guides.
3. Remove left side shroud panel and left center pillar lower trim and carpet restrainer.
4. Remove Connector Position Assurance (CPA) and disconnect sensor electrical connector.
5. Lift carpet to gain access to electrical harness routing conduits.
6. Remove sensor mounting bolts, then snap open conduits and remove sensor wiring.
7. Remove passenger compartment sensor.
8. Reverse procedure to install, noting the following:
a. After completing installation, rearm system as described in Air Bag System Disarming & Arming.
b. Turn ignition key to the On position and verify the AIR BAG or SIR warning lamp flashes seven to nine times, then turns off. If warning lamp
does not operate as specified, refer to System Diagnosis.
