Beretta V6-173 2.8L (1989)
3.
Drill a (1/8") hole, approximately 1/2 inch below area to where original retaining screw was located. (See Illustration)
IMPORTANT:
A small amount of carpet will have to be removed to prevent the drill from becoming entangled in the carpet.
4.
Install trim panel to door and raise glass to full up position, drill a 1/16" pilot hole into door inner panel through the hole drilled in map pocket in
Step 3.
5.
Drive a flat headed-self tapping 5/32 X 1 inch long screw through map pocket into door inner panel.
Labor Operation Number:
T1460 Right Side T1461 Left Side
Labor Time:
.5 Each Side