Beretta V6-173 2.8L (1989)
Temperature Warning Lamp/Indicator: Testing and Inspection
If the red light is not lit when the engine is being cranked, check for a burned out bulb, an open in the light circuit, or a defective ignition switch.
If the red light is lit when the engine is running, check the wiring between light and switch for a ground, temperature switch defective, or overheated
cooling system. As a test circuit to check whether the red bulb is functioning properly, a wire which is connected to the ground terminal of the
ignition switch is tapped into its circuit. When the ignition is in the start engine cranking position, the ground terminal is grounded inside the
switch and the red bulb will be lit. When the engine is started and the ignition switch is in the on position, the test circuit is opened and the bulb
is then controlled by the temperature switch.
