Beretta V6-173 2.8L (1989)
Crankshaft Main Bearing Seal: Service and Repair
REMOVE OR DISCONNECT
Tool required:
^ J 34686 Rear Main Seal Installer
1. Support engine with J 28467-A.
2. Transaxle.
3. Flywheel.
4. Confirm rear seal leak.
5. Insert a screwdriver or similar tool in through the dust lip at an angle as shown. Pry seal out by moving the handle of the tool towards the end of
the crankshaft pilot. Repeat as required around the seal until seal is removed.
CAUTION Care must be taken not to damage crankshaft O.D. surface or chamfer with pry tool.