Beretta V6-173 2.8L (1989)
well opening. Assembly must be routed behind brake booster and be positioned as shown in attached illustration.
11.
Connect outlet (return) and then inlet (pressure) fittings to steering gear torquing fittings to 27 N-m.
IMPORTANT:
Inspect to insure O-rings are present on fittings prior to connecting to gear.
12.
Tighten and torque both left steering gear clamp nuts and then right nuts to 38 N-m.
13.
Install pipe retainer and clip.
14.
Install tie rod/engine wheel well splash shields.
15.
Connect hose to cooler pipe and torque clamps to 1.7 N-m.
16.
Install wheel and tire assembly and lower vehicle.
17.
Fill with fluid and bleed power steering system following applicable shop manual procedure (Section 3B3).
IMPORTANT:
After bleeding of system, insure fluid level is at the "Hot" mark after system has been stabilized at its normal operating temperature.
18.
Check for leaks, correct as required and bleed system.
Labor Operation Number:
T1455
Labor Time:
1.6 Hours
