chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Throttle Position Sensor > < Power Steering Pressure Switch|Locations|Page 481
Page 2
background image

Chart C-1E Wiring Diagram

CIRCUIT DESCRIPTION:

The power steering pressure switch is normally open to ground, and CKT 901 will be near battery voltage.

Turning the steering wheel increases power steering oil pressure and its load on an idling engine. The pressure switch will close before the load can
cause an idle problem.

Closing the switch causes CKT 901 to read less than 1 volt. The ECM will increase the idle air rate and disengage the A/C relay. 

TEST DESCRIPTION:  Numbers below refer to circled numbers on the diagnostic chart.

1.

Different makes of "Scan" tools may display the state of this switch in different ways. Refer to "Scan" tool operator's manual to determine how this
input is indicated. 

2.

Checks to determine if CKT 901 is shorted to ground. 

3.

This should simulate a closed switch.

DIAGNOSTIC AIDS:

^

A pressure switch that will not close, or an open CKT 901 or 450, may cause the engine to stop when power steering loads are high.

^

A switch that will not open, or a CKT 901 shorted to ground may affect idle quality and will cause the A/C relay to be de-energized.

Throttle Position Sensor > < Power Steering Pressure Switch|Locations|Page 481