Beretta V6-173 2.8L (1989)
Figure 1
6. Measure transaxle heights-see Figure 1.
Side-to-side transaxle heights should be equal. If side-to-side differences are greater than 6 mm (1/4 inch), follow the engine shake-down procedure
below:
A. Loosen the engine/transaxle to body mounts.
B. Start the vehicle and shift from reverse to drive slowly three times to re-settle the engine/transaxle assembly.
Figure 2
C. Block vehicle wheels and apply park and service brakes. With an assistant watching the engine, make sure the transmission mount is not
grounded against the stop in drive. If so, shift the mount until the rubber stop is not contacting the mount with the engine in drive. Refer to
Figure 2. (1992 "J" car only).
D. Re-tighten all engine and transaxle mounts to body.
E. Check to see if the engine/transaxle is not level by measuring as described above. If it is not level, shim engine/transaxle mounts to raise the side
with the lowest reading, using appropriate wheel alignment shim stock. Labor operation T4639.
