Beretta V6-3100 3.1L MFI VIN M (1994)
MPFI Injector P/N Location
Each injector is calibrated for a specific flow rate. When replacing fuel injectors, order replacements with the identical part numbers as the old injectors.
Reverse procedure for installation.
ASSEMBLY NOTES
1.
Be sure to thoroughly clean old gasket material from all surfaces before installation.
CAUTION: Be careful when doing this so as not to damage machined surfaces. Because aluminum is such a soft metal, it is recommended that power
tools NOT be used for cleaning machined aluminum surfaces.
1.
Lubricate new injector O-ring seals with clean engine oil prior to installation.
2.
Use new injector retaining clips and install clips with openings facing the injector electrical connectors.
3.
Install injectors into the fuel rail sockets with the electrical connector facing forward.
^
Push in far enough to engage the retainer clip with the machined slots on the rail socket.
4.
Tighten upper manifold fplenum to lower manifold bolts to 18 lb.ft (25 Nm.)
