Beretta V6-3100 3.1L VIN M SFI (1995)
Oil Pan: Service and Repair
OIL PAN
Oil Pan
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Serpentine belt, See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair
-
loosen but do not remove upper A/C compressor bolts (if equipped).
3. Raise vehicle and support.
4. Drain crankcase.
5. Right front wheel assembly and splash shields.
6. Engine mount strut from suspension support.
7. Right front ABS wheel speed sensor harness from the right suspension support.
8. Right front ball joint and stabilizer link. See: Steering and Suspension/Suspension/Ball Joint/Service and Repair
9. Right side suspension support.
10. Remove lower A/C compressor bolts, position compressor aside and support. See: Heating and Air Conditioning/Compressor HVAC/Service and
Repair
11. Engine mount strut bracket and engine to transaxle brace.
12. Oil filter and starter.
13. Flywheel inspection cover.
14. Oil pan retaining bolts and oil pan.
Clean
^
Oil pan flanges.
^
Oil pan rail.
^
Front cover.
^
Rear main bearing cap.
^
Threaded holes.
INSTALL OR CONNECT
1. New gasket.