Beretta V6-3100 3.1L VIN M SFI (1995)
Throttle Position Sensor: Service and Repair
Throttle Body Assembly
REMOVE OR DISCONNECT
l.
Air inlet duct.
2. Throttle Position (TP) sensor electrical connector.
3. Remove TP sensor attaching screws and retainers.
4. Sensor and 0-ring.
INSTALL OR CONNECT
1. With throttle valve in the normal closed idle position, install TP sensor and 0-ring on throttle body assembly.
2. Two TP sensor screws.
Tighten
^
Screws to 2.0 Nm (18 lb. in.).
3. TP sensor electrical connector.
4. Air inlet duct.
