Beretta V6-3100 3.1L VIN M SFI (1995)
REMOVE OR DISCONNECT
1. Wiring harness from Powertrain Control Module (PCM).
2. Mounting bracket from PCM.
3. Access cover from PCM.
Important: Do NOT remove any other screws.
Removal of the plug-in Knock Sensor (KS) module can be accomplished by two methods as illustrated.
Method 1:
1. Apply two opposing forces on either side of the latch mechanism as shown and pull unit up from the header. Reinstallation accomplished by
pushing the unit toward the header.
Method 2:
2. Apply force toward the plug-in KS module with the thumb or forefinger with an opposing force on the opposite side of the module as shown
below. Reinstallation is done as stated in Method 1.