Blazer 2WD V6-4.3L VIN X (2004)
Auxiliary Step / Running Board: Service and Repair
Assist Step Replacement (ZR5)
Assist Step Replacement (ZR5)
Removal Procedure
1. Remove 8 nuts (1) and 4 U-bolts (3) securing the assist step assembly to the mounting brackets.
2. Remove the 11 nuts (2) and 4 brackets.
3. Remove the plastic end caps from the assist step assembly, if required.
1. Remove the 3 screws from the assist step assembly.
2. Remove the plastic end cap by pulling the cap straight out of the step assembly.
4. Remove the plastic step pads, if required, by breaking the plastic pad from the assist step assembly.
Installation Procedure
1. Install new plastic step pads to the assist step assembly by pressing the new pads into place.
2. Install the plastic end cap to the assist step assembly.
1. Install the plastic end cap by pressing the cap straight into the assist step assembly.
2. Install 3 screws into the step assembly.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the 4 brackets and 11 nuts (2).
Tighten to 35 N.m (26 lb ft).
4. Install the assist step assembly to the mounting brackets with 4 U-bolts (3) and 8 nuts (1).
Tighten the step assembly nuts to 20 N.m (15 lb ft).
