Blazer 2WD V6-4.3L VIN X (2004)
Guide the cable through the cowl panel underneath the instrument panel from the inside of the vehicle.
Installation Procedure
1. Install the hood latch assembly to the vehicle.
Guide the cable through the cowl panel underneath the instrument panel from the inside of the vehicle.
2. Guide the cable along the left fender behind the antilock brake module, the underhood fuse block, and the windshield wiper/washer reservoir.
3. Route the cable around the end of the radiator support.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the hood release cable and the lever bolts to the cowl side panel.
Tighten the hood release cable and the lever bolts to 9 N.m (80 lb in).
5. Secure the release cable to the side of the cowl with adhesive tape.
6. Install the hood release cable to the retaining clips.
