Blazer 2WD V6-4.3L VIN X (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate Window
Strut Replacement - Lift Gate Window
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Open and support the liftgate window.
Notice: Refer to Liftgate/Hood Assist Rod Notice in Service Precautions.
2. Remove the retainer from the hinge pin.
The hinge pin is located at the upper end of the liftgate window strut.
Discard the retainer.
3. Remove the hinge pin from the upper end of the liftgate window strut.
Discard the hinge pin.
4. Lift up the retainer clips on the liftgate window struts using a small flat-bladed tool.
5. Remove the lower end of the liftgate window struts from the ball joint.
6. Remove the liftgate window struts from the liftgate window.
Installation Procedure
1. Position the liftgate window struts to the liftgate window.
2. Install the lower end of the liftgate window struts to the ball joint. Press in to place until fully seated.
3. Install the new hinge pin to the upper end of the liftgate window strut.
4. Install the new retainer to the hinge pin.
5. Remove the support from the liftgate window.
6. Close the liftgate window.