Blazer 2WD V6-4.3L VIN X (2004)
Lower Side Moulding / Trim: Service and Repair
Molding Replacement - Rear Body Side - Lower Front (Chevrolet)
Molding Replacement - Rear Body Side - Lower Front (Chevrolet)
Tools Required
J 25070Heat Gun
Removal Procedure
1. Heat the body side molding using a J 25070. Hold the heat gun approximately 152 mm (6 in) from surface.
Apply heat using a circular motion for about 30 seconds.
Important: Be careful not to scratch or chip the paint.
2. Peel the body side molding from the panel surface using a flat-bladed tool.
3. Remove all adhesive from the body panel and the back of the body side molding using a 3M(TM) scotch brite molding adhesive remover disk
3M(TM) P/N 07501 or equivalent.
4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
Installation Procedure
1. Warm body panel with a heat lamp or heat gun to a minimum of 21°C (70°F).
2. Peel the backing from the front end of the body side molding.
Important: Do not touch the adhesive backing.
3. Press the body side molding to the body while continuing to remove the backing.
4. Hand roll the body side molding to the body in order to ensure proper adhesion.
