Blazer 2WD V6-4.3L VIN X (2004)
6. Using a small flat-bladed tool, gently pry the eight screw covers from the interior garnish molding.
7. Remove the eight screws securing the garnish molding to the lower frame assembly.
8. Remove the garnish molding from the vehicle.
Installation Procedure
1. Position the garnish to the headliner.
2. Loosely install one forward and one rearward screw to the garnish molding in order to hold the garnish molding into position.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the remaining screws.
The two short screws are positioned on each side of the motor/actuator.
Tighten the screws to 1.5 N.m (13 lb in).
