chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Power Locks > < Keyless Entry System - Characteristics of Operation
Page 2
background image

DO NOT REPLACE ANY COMPONENTS.

Re-synchronization must be performed if the following conditions exist:

The batteries of the keyless entry transmitter have been replaced. A keyless entry transmitter is malfunctioning.

If all of the transmitter buttons fail to function check the battery and transmitter using tester J 43241. Refer to Corporate Bulletin Number 83-90-12.

If the transmitter passes the test program the RKE system following the procedures in the Keyless Entry sub-section of Body & Accessories in the
Service Manual.

Remember when programming the system, all transmitters for the vehicle must be present for the programming to be successful.

On many 2006 vehicle lines RKE transmitter commands can be viewed using a scan tool (under RCDLR Data Displays).

If the transmitter fails the test with the tester J 43241 replace the batteries and retest the transmitter using the tester J 43241. If the transmitter still fails
the test replace the transmitter.

THE FOLLOWING CLAIM TYPES ARE NOT COVERED UNDER THE VEHICLE WARRANTY:

The battery is considered a consumable battery and is covered for the first 12 months only. Refer to "Maintenance" in the In-Vehicle Warranty Booklet.
Battery life is determined by the number of times a pad on the transmitter has been used, not by time or mileage and as such, battery replacement would
be considered owner maintenance (i.e. batteries in a flash light, engine oil changes).

Transmitter replacement when all buttons work, using the tester J 43241 as outlined in Corporate Bulletin Number 83-90-12.

Personalization programming through the DIC or Tech 2(R).

Lost/replacement transmitter reprogramming.

Used car transmitter replacement programming.

Transmitter damage due to misuse, such as any liquid spilled on/in the transmitter or damage from animals chewing on the transmitter, etc.

Broken transmitter cases where the key ring attaches to the case. If the case is broken in this area, it is due to mounting the transmitter direct to the key
ring without the protection of the small ring. The small ring acts like a universal joint/flex joint and helps protect the transmitter from this type of
damage. Refer to Corporate Bulletin Number 03-08-52-003 for EXCEPTIONS to this rule.

Garage door opener programming.

Disclaimer

Power Locks > < Keyless Entry System - Characteristics of Operation