Blazer 2WD V6-4.3L VIN X (2004)
Power Mirror Switch: Service and Repair
Power Folding Outside Mirror Switch Replacement
POWER FOLDING OUTSIDE MIRROR SWITCH REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable.
2. Remove the folding outside mirror switch by carefully using a flat-bladed tool in order to pry up on the leading edge.
3. Remove the accessory switch panel from the armrest. Use a flat-bladed tool in order to carefully pry the cover up at the front leading edge leaving
the electrical connections connected.
4. Disconnect the electrical connector from the power folding mirror switch.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the power folding mirror switch.
2. Install the power accessory switch mounting panel to the armrest. Ensure that the retainers lock into place.
3. Install the power folding mirror switch to the door trim panel. Ensure that the retainers lock into place.
4. Connect the battery negative cable.