Blazer 2WD V6-4.3L VIN X (2004)
7. Install the boot seals into the caliper housing bores using the J8092 and the J43885.
Brake Caliper Overhaul - Rear
Brake Caliper Overhaul - Rear
Disassembly Procedure
1. Drain all the brake fluid from the caliper.
2. Pad the interior of the caliper with clean shop towels.
Caution: Refer to Eye Protection Caution in Service Precautions.
Notice: Refer to Safety Glasses and Compressed Air Caution in Service Precautions.
3. Remove the piston from the caliper bore.
4. Remove the boot from the caliper bore. Do not scratch the housing bore.
