Blazer 2WD V6-4.3L VIN X (2004)
2. Install the brake caliper bolts to the mounting bracket.
Tighten the brake caliper bolts to 51 Nm (38 ft. lbs.).
Notice: Refer to Installing Hoses without Twists or Bends Notice in Service Precautions.
Important: When performing the following service procedure, DO NOT reuse the old bolt washers. Always use new washers.
3. Install the brake hose bolt and washers.
Tighten the brake hose bolt to 54 Nm (40 ft. lbs.).
4. Fill the brake master cylinder to the proper level.
5. Bleed the brake calipers.
6. Install the tire and wheel assembly,
7. Lower the vehicle. Refer to Vehicle Lifting.
Brake Caliper Replacement - Rear
Brake Caliper Replacement - Rear
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.