Blazer 2WD V6-4.3L VIN X (2004)
5. Turn the J 41552 clockwise in the slots in the rotor.
6. Perform the following steps in order to remove the pulley rotor and bearing assembly:
6.1.
Hold the J 41552 in position.
6.2.
Tighten the puller screw against the puller guide.
6.3.
Remove the pulley rotor and bearing assembly.
7. Use the following procedure in order to properly support the rotor hub during bearing removal in order to prevent pulley rotor damage:
7.1.
Remove the forcing screw from the J 41552.
7.2.
Ensure that the puller tangs still engage in the rotor slots.
7.3.
Invert the assembly onto a solid flat surface or blocks.
8. Use the J 9398-A and the J 29886 in order to drive the bearing out of the rotor hub.
NOTE: It is not necessary to remove the staking in front of the bearing to remove the bearing, however, it will be necessary to file away the old stake
metal for proper clearance for the new bearing to be installed into the rotor bore or the bearing may be damaged.
V7 - Direct Mount
CLUTCH ROTOR AND/OR BEARING REMOVAL (V7 - DIRECT MOUNT)
TOOLS REQUIRED
-
J 33023-A Puller Pilot
-
J 41552 Compressor Pulley Puller
-
J 41790 Compressor Holding Fixture
1. Remove the A/C compressor from the vehicle.
2. Clamp J 41790 in a vise and attach the A/C compressor to J 41790.
