Blazer 2WD V6-4.3L VIN X (2004)
4. Install the 6 retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions. See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to.................1.9 N.m (17 lb in).
5. Install the evaporator and blower module to the vehicle.
IMPORTANT:Ensure that the evaporator and blower module to the cowl seal is in place.
6. Install the evaporator and blower module mounting fasteners.
IMPORTANT:Install the evaporator and blower module heat shield mounting bracket with the evaporator and blower module mounting nuts.
Tighten
Tighten the fasteners to.....................4.5 N.m (40 lb in).
7. Install the evaporator and blower module heat shield.
8. Install the evaporator and blower module heat shield mounting screws.
Tighten
Tighten the screws to.......................2.2 N.m (19 lb in).
9. Install the evaporator tube.
10. Install the accumulator.
11. Install the blower motor resistor.
12. Install the right fender.
13. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
14. Leak test the fittings of the components using the J 39400-A.