Blazer 2WD V6-4.3L VIN X (2004)
INSTALLATION PROCEDURE
1. Install the vacuum control assembly to the vehicle.
2. Install the vacuum control assembly retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions. See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to......................2 N.m (18 lb in).
3. Connect the vacuum harness connector to the vacuum control assembly.
4. Connect the electrical connector (4) to the vacuum control assembly (5).
5. Install the instrument panel carrier.
