Blazer 2WD V6-4.3L VIN X (2004)
6.
Remove the screw at the front of the console.
7.
Pull downward on the rear of the console in order to remove the sunroof console from the roof.
8.
Disconnect the electrical connectors (1, 5, 6) as needed.
9.
Remove the sunroof console.
Note:
Use caution not to damage or crease the headliner while repositioning.
10.
Reposition the front of the headliner down and out of the way of the compass mounting bracket.
11.
Remove the screw that retains the sunroof console mounting bracket to the roof.
12.
Remove the compass sensor mounting bracket from the vehicle.
13.
Remove the front center clip-in retainer from the compass sensor mounting bracket.
14.
Install the clip-in retainer on the new compass sensor mounting bracket, P/N 15106819.
15.
Trim the headliner as shown above in order to allow clearance for the new compass mounting sensor bracket. Follow the dimensions below for the
trimming of the sensor bracket.
^
A = 71 mm (2.8 in)
^
B = 19 mm (0.75 in)
^
C = Center line of headliner
^
D = 9.5 mm (0.375 in)
