Blazer 2WD V6-4.3L VIN X (2004)
Distributor: Service and Repair
Distributor Overhaul
DISTRIBUTOR OVERHAUL
DISASSEMBLY PROCEDURE
NOTE: Refer to Distributor Driven Gear Can Be Installed in Multiple Positions Notice in Service Precautions.
1. Align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (2).
2. With the gear in this position, the rotor segment should be positioned as shown for a V6 engine (1). If not, replace the distributor.
3. Remove the two screws from the rotor.
4. Remove the rotor.