Blazer 2WD V6-4.3L VIN X (2004)
8. Install the distributor cap.
9. Install two new distributor cap screws.
Tighten
Tighten the screws to 2.4 N.m (21 lb in).
10. Install the electrical connector to the distributor.
11. Install the spark plug wires to the distributor cap.
12. Install the ignition coil wire. Note the correct orientation of the wire boot.
IMPORTANT: If the MIL is turned ON after installing the distributor, and a DTC P1345 is found, the distributor has been installed incorrectly.
13. Repeat installation procedure 2 if the malfunction indicator lamp is turned ON after installing the distributor.
