Blazer 2WD V6-4.3L VIN X (2004)
3. Locate the 2-wire dress cover locking tabs that are opposite the wire end of the connector. Use a small flat-bladed tool to unlock the dress cover.
4. Once the front 2 locks are unlocked, lift the back 2 locks that are on the wire side of the connector.
5. If the connector has a nose piece, use a small flat-bladed tool to remove the nose piece by inserting the blade into the slot on the front of the
connector and prying up on the nose piece.
IMPORTANT: Always use care when removing a TPA in order to avoid damaging it.
6. Remove the TPA by inserting a small flat-blade tool into the small slot on the TPA and pushing down until the TPA comes out of the connector.
Gently pry the TPA out of the connector.