Blazer 2WD V6-4.3L VIN X (2004)
3. Install the CPA to the I/P module yellow 2-way connector (1) located behind the I/P support.
4. Install the SIR fuse to the I/P fuse block (1) located in the I/P fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
Zone 8
1. Remove the key from the ignition.
2. Connect the I/P module yellow 2-way connector (1) located behind the main I/P support.
3. Install the CPA to the I/P module yellow 2-way connector (1) located behind the I/P support.
