Blazer 2WD V6-4.3L VIN X (2004)
6. Disconnect the wires from the solenoid.
7. Remove the starter from the vehicle. Note the location of the shims, if equipped.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Connect the wires to the solenoid.
Tighten
-
Tighten the battery positive cable nut to 9 N.m (80 lb in).
-
Tighten the engine wiring harness to starter nut to 1.9 N.m (17 lb in).
1. Install the starter and the inboard starter mounting bolt. Do not tighten.
