Blazer 2WD V6-4.3L VIN X (2004)
Pitman Arm: Service and Repair
On Vehicle Service
Pitman Arm Replacement (RWD)
^
Tools Required
-
J 24319-B Steering Linkage and Tie Rod Puller
-
J 29107-A Pitman Arm Puller
-
J 6632-01 Pitman Arm Puller
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Important: Use the proper tool in order to remove the relay ball stud nut.
2. Remove the relay rod ball stud at the pitman arm.
3. Remove the relay rod ball stud from the pitman arm using J24319-B.
Notice: Do not hammer on the pitman arm, pitman arm shaft or puller. Damage to the pitman arm or steering gear may result.
4. Remove the pitman arm nut and washer from the steering gear.