Blazer 2WD V6-4.3L VIN X (2004)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and suitably support the vehicle with safety stands. Refer to Vehicle Lifting.
2. Remove the tire and the wheel.
3. Remove the rotor.
Important: Do not hammer on a wheel stud.
4. Remove the wheel stud bolt using J 43631.
Installation Procedure
1. Install the wheel stud to the wheel hub and bearing.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install 4 washers and the nut to the wheel stud.
^
Tighten the wheel stud nut to 130 Nm (95 ft. lbs.), drawing in the wheel stud.
3. Remove the nut and the washers.
4. Install the rotor.
5. Install the tire and the wheel.
6. Lower the vehicle.