Blazer 2WD V6-4.3L VIN X (2004)
9. Ensure that the shift controller is in the NEUTRAL position.
10. Raise the vehicle.
11. Install the range selector cable to the bracket.
12. Install the retainer (1) to the range selector cable and transmission bracket.
13. Ensure that the transmission range selector lever is in the NEUTRAL position.
14. Following the adjustment procedure, install the range selector cable (2) to the range selector cable lever ball stud (1).
15. Install the positive assurance pin to the bracket.
16. Install the transfer case shield, if equipped. Refer to the appropriate procedure:
^
Transfer Case Shield Replacement in Transfer Case-NVG 233-NP1
^
Transfer Case Shield Replacement in Transfer Case-NVG 236-NP8
17. Lower the vehicle and check for proper operation. Repeat the adjustment procedure if necessary.