Blazer 2WD V6-4.3L VIN X (2004)
Center Support: Service and Repair
Propeller Shaft Center Support Bearing Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the propeller shaft.
3. Remove the center bearing using the following steps:
3.1.
Stand the propeller shaft (2) on end in the press (1) with the center bearing (3) supported by the press bars (4).
3.2.
Press the propeller shaft (2) down and off the center bearing (3).
Installation Procedure
1. Install the center bearing (3) onto the propeller shaft (2) by pressing the center bearing onto the shaft using a press (1).
Ensure that the center bearing is fully seated on the propeller shaft.
2. Install the propeller shaft.
3. Lower the vehicle.