Blazer 2WD V6-4.3L VIN X (2004)
8. Continue to apply pressure and rock the cover until the second locking leg is unseated. Repeat procedure for the other side of the dress cover and
remove the cover.
9. Use J 38125-12A tool to gently lift the terminal retaining tab while gently pulling the wire out of the back of the connector. Always remember
never use force when pulling a terminal out of a connector. If the terminal is severely bent or damaged, push the wire out of the front of the
connector instead of pulling it through. This will prevent damage to the internal seals of the connector. Once the terminal is pushed out of the
connector, cut the wire as close to the terminal as possible and pull the wire through the connector.
TERMINAL REPAIR PROCEDURE
Use the appropriate wire assembly kit available through Saturn Service Parts.
1. Slide the new terminal into the correct cavity at the back of the connector.
2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is
locked in place by gently pulling on the wire.
3. Replace the nose piece.
4. Replace the dress cover.
Repairing Connector Terminals
REPAIRING CONNECTOR TERMINALS
TOOLS REQUIRED
J 38125-C Terminal Repair Kit
Use the following repair procedures in order to repair the following:
-
Push to Seat terminals
-
Pull to Seat terminals
-
Weather Pack(R) terminals
Some terminals do not require all of the steps shown. Skip the steps that do not apply for your immediate terminal repair. The J 38125-C contains further
information.
1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.
