Blazer 2WD V6-4.3L VIN X (2004)
13. Pull the washer hose (1) into the vehicle though the bulkhead.
14. Cut the old washer hose off where it enters the body wiring harness (2).
15. Remove the hose end from the vehicle.
INSTALLATION PROCEDURE
1. Install the hose to the vehicle.
2. Route the hose (1) out though the bulkhead.
3. Route the hose along the body harness (2), and tape the hose to the body harness with 3 wraps of electrical tape every 100 mm (4 in).
4. Seat the hose grommet (2) into the bulkhead.
5. Remove the plug from the rear washer pump nozzle.
