Blazer 2WD V6-4.3L VIN X (2004)
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the transmission mounting screws.
Tighten
Tighten the wiper transmission mounting screws to 8 N.m (70 lb in).
IMPORTANT:
-
Lubricate the inside of the socket with white lithium grease (GM P/N 9985885) or equivalent.
-
The wiper transmission must be assembled to the crank arm past the second detent so the seal is compressed to a maximum height of 25.5 mm (1
in).
1. Install the transmission drive link to the wiper motor crank arm using the J 39529.
2. Install the air inlet grille panel.
3. Install the wiper arms.