Blazer 4WD V6-4.3L VIN X (2005)
1. Install the rubber bumper (1) to the latch.
2. Rotate the actuator toward the latch in order to fully engage the rubber bumper into the latch.
3. Install the actuator to the top of the latch.
IMPORTANT: Ensure that the first tooth of the gear on the actuator and the first tooth of the gear on the latch align and interlock properly.
4. Install the 2 screws (2) that retain the actuator (1) to the latch.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 0.75 N.m (6 lb in).
5. Install the latch to the door.
6. Install the water deflector.
7. Install the door trim panel.