Blazer 4WD V6-4.3L VIN X (2005)
3. Apply pressure to the SOP switch until the switch is completely seated.If the switch does not slide into position, the ridges on the drive cable
housings will not go into the grooves on the back of the SOP switch. Lift each cable into the switch, and press down on the assembly until the
assembly is completely seated.
4. Install the screw which secures the SOP switch to the sunroof module.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw to 3.4 N.m (30 lb in).
5. Connect the electrical connector to the SOP switch.
6. Install the sunroof motor/actuator.
7. Remove the position lock pin (1).
8. Remove the 2 alignment pins from the cable mechanisms and/or from the cam mechanisms.
9. Install the sunroof control module, but do not install the headliner until after the sunroof operation has been verified.
10. Verify the operation of the sunroof module.
11. Install the sunroof window.
12. Install the headliner.
